ROLL UP PRESTIGE
The Prestige model is available in two widths
|
830mm
|
960mm
|
 |
 |
Design Notes
The 10mm area at the top of the graphic is where the clamp is attached. This is generally not visable in the final stand.
The bleed area marked on the template above is the part of the graphic that is wrapped inside the stand. This area can be left blank if required but must be allowed for in your design.
Construction Notes
The best construction for a Roll Up Prestige is to print your graphic on a quality synthetic media such as our Sihl Synthetic Outdoor. An alternative to this is a Matt Poster Paper followed by a Matt Laminate with a 2mm edge. Please note that if using your display stand for a trade show overseas you may be required to use fire retardant media such as our EXPO banner.
|
.jpg)
.jpg){kind=small}
